After the kettle body before the stop line grouping is complete, open to the autoclave autoclave autoclave door, finished first with a winch pulled the kettle car aerated concrete wall panels proxy kettle, and then prepare autoclaved the kettle vehicle hoist pull into the autoclave with conservation. Kettle car manufactures bridge cranes hanging to the finished products with aerated concrete wall, then use a fork-lift truck to transport the finished aerated concrete wallboard factory yard, empty kettle cars and kettle hanging back to the carriage floor Online aerated concrete wall behind the equipment to clean hoist frame at the back yard for the next cycle using ordinary masonry mortar masonry infill walls, sintering hollow bricks, lightweight aggregate concrete water absorption larger small hollow block should Early 1d ~ 2d pouring (spray) water wet. Autoclaved aerated concrete block using autoclaved aerated concrete block masonry mortar or masonry mortar general, it should be in the day of masonry block masonry surface water wet. Bulk moisture level should meet the following requirements: 1) the relative moisture content of the sintered class block material is preferably 60% to 70%; 2) the relative moisture content of the non-sintered type block material is preferably from 33% to 50%; 3) Masonry moisture on the wall of the block material may not be saturated water content. Note: The use of "dry assemble Method" in construction of autoclaved aerated concrete block, without its pouring (sprinkling) water wet.